Laboratory of Automatic Control and Mechatronics (room PL 203, door No. CA 02 055)

The lab facilitates research and development activities of the department in the areas of modelling, identification and control of dynamic systems, as well as lessons of some subjects of follow-up master’s degree Process Control. The lab is equipped with three PC with Matlab & Simulink, Visual Studio, LabVIEW software and also specialized software for work with industrial controllers (tune parameters, on-line optimization of parameters, programming, and simulation). There are 6 working stations equipped with laboratory power sources, industrial controllers by company PMA and other additional equipment in the lab.
 
Photo gallery
 

Equipment:

  • 6 x PC Dell Optiplex 390 with specialized SW
  • 3 x Multifunction DAQ Device NI USB-6008 (8 AI, 2 AO, 10 kS/s, 12-bit)
  • 3 x Multifunction DAQ Device NI USB-6009 (8 AI, 2 AO, 48 kS/s, 14-bit)
  • 6 x Matrix power source MPS-3003L-3
  • 3 x KS 90-1 industrial process controller
  • 3 x KS 98-1 programable process controller (multi-function unit)
  • Motor-generator training device